Pricing FAQ's
Main Page
Services Included
Optional Services
Parts Preparation
A Few Words on Pricing
Caring for Powdercoated Parts
Contact Us!
|
Services Included in Pricing
Cleaning
Corrosion resistant pre-treatment
De-gassing*
Masking
Powder Coating with one single stage stock color
Optional Services Offered
2 Stage Colors including translucent candy colors and metallic colors
Non Stock Colors available as a special order (we have about 200 stock colors to choose from)
Clear Top Coat over another color (required with chrome but adds depth to any existing color)
Specialty Powders such as textures, neons, veins, hammertones and high heat resistant colors
Polishing of highlights such as valve cover lettering, cylinder fins, etc.
Media Blasting of parts with sand, plastic, glass beads or aluminum oxide as is appropriate
Chemical Stripping of existing Powder Coating
Part preparation
All prices are based on parts that are stripped to bare metal, degreased and ready for paint. Any cleaning of excessive rust, dirt, oil or grease will be extra (unless we are to media blast). Any media blasting will be extra. Any chemical stripping of previously powder coated parts will be extra. All bearings, seals, gaskets, bushings, plastic pieces, etc. must be removed to withstand the high oven curing temperatures. We do not disassemble or assemble parts. Chemical pre-treatment and media blasting may be used on your parts and it is your responsibility to thoroughly clean all parts before assembly. We will mask only threaded holes and gasket surfaces on parts unless we are advised otherwise, please note any special masking needs you have in writing when delivering the parts to us.
Back to the Main Page | Back to the Top of This Page
A Few Words on Pricing
Our basic pricing is to give you a general idea of cost. Pricing may vary in some cases
Discounts available for multiple items of the same color done at the same time
Discounts available to qualifying businesses
A $15 setup fee will be added to all orders under $50
Back to the Main Page | Back to the Top of This Page
Caring for Powder Coated Parts
While Powder Coated finishes are tougher and more flexible that conventional paints, they can be scratched. Use the same care you would use to clean your car. Gently wash with a clean, soft, damp cloth and mild detergent followed by a clear water rinse.
* Some cast aluminum and magnesium parts may experience out-gassing causing minute pinholes in the finish. We will take every precaution to avoid it, however we can’t be held responsible for out-gassing caused by porous castings.
Back to the Main Page | Back to the Top of This Page
|
